Instructions
Welcome > Electronic speedometer > Instructions

Instructions

A.  The best place to install the motor unit is in the engine compartment against the bulkhead.

 

B.  When the motor unit is in place cut the original speedometer cable to length (a few cm longer to avoid pressure on the cable) Disconnect the cable behind the dashboard. Pull out the inner cable and then cut of another 1cm from the outer cable (engine side).

 

C.  The magnet holder is placed (as close as possible to the gearbox (transmission)) on the drive shaft. Clean the shaft and place the magnet holder. Fasten with the two screws. When the holder is straight glue it with locktite or super glue.

 

D.  Place the sending unit with a bracket (not included) 6 to 10 mm from the top of the magnets. The highlighted black point should go towards the magnets.

 

E.  Place the box with the electronics under you dashboard. Connect the sending unit cable in the box (d). Connect the motor unit cable to the motor (blue to blue, red to red) Connect the red cable to the positive terminal (12v.) and black to negative terminal(ground).

 

BE SURE TO CONNECT THEM CORRECTLY OTHERWISE IT WILL BURN THE ELECTRONICS.